News

NOTICE

Home > NOTICE > Notice

Notice

Source: viewed:

The Notice of Using Rubber Tracks

1. Adjust the tension of the rubber crawler so that the height,the variable range is 10-20mm when the machine is lifted.Readjust when the tension decreases.(Be careful because the rubber crawler may comee off if the tension is too low).

2. Avoid projections from the frame around the rubber crawler,especially on its inner circumference.(Rubber crawlers are easily deformed;if it comes into contact with teh frame,an accident such as the rubber being cut can occur.

3. Avoid sharp projetctions when travelling.

4. Avoid turing too fast on concrete roads with a high coefficient of friction because this can cause accidents such as cutting the rubber.

5. Be careful that no oil,etc adheres to the rubber track.If it does,wipe it off immediately.

6. When storing for long periods,keep indoors,away from direct sunshine and rain.

7. Replace as soon as possible when abrasion of the sprockets is observed.



Causion for Rubber Track System:

First, please take good care of our goods, like taking good care of your vehicle;

 

Second, the installation of this product, this is normal that response surface friction coefficient increases, there will be the vehicle is coasting distance plummeted;so the shift need to turn

after express speed to 3000 rpm, rapid shift.

 

Third, when you install the product driving off-road and complex road conditions, please first in 30 kilometers, traffic is a good location to ensure driving skilled and products running in.

 

Four, 100 kilometers exercise mileage, speed should not more than 30 km / h;

 

Five, after mounting assembly recommends a maximum speed of the vehicle is 50Km / h.

 

Six, in the 100 km run-in period, to be checked once every 10 kilometers tension, such as crawler loose, please tighten the tensioner;

 

Seven, do not speeding, overloading driving, press the product model assembled vehicles equipped;

 

Eight,Track do not contaminated with oil and corrosive liquids;

 

Nine, is prohibited beyond product temperature and environments;

 

Ten, please clean out the outer tread Track stones and other impurities in when not in use;

 

Eleven,Do not use a metal weapon damage crawler;

 

Twelve, Non-supporting non-flame retardant crawler traveling in the fire;

 

Thirteen, small speed when turning Do not more than 5 km / h;

 

Fourteen, non-static pivot turn;

 

Fifteen, check the connection plate screws and other parts of the screw is loose, the installation is close, if loose, please fasten in time;

 

Sixteen, when not used for long, put the product stored in a cool environment.



Customer Notes:

1, due to the Buyer before and after the installation is not anti-turn device, causing the product, damage to the vehicle,Seller shall not be liable.

2, install the product, greatly enhanced by the performance of the vehicle, but does not mean the vehicle can travel any road unconditional situation, there are still certain restrictions by. Specific conditions of use, please contact me OK. We will have to provide the material before and after the turn.

 


Copyright © jingyu international Tel:021-37580296 Fax:021-37580295